Sorting Capabilities

ROLL SORT – can remove foreign material such as roll-offs, heat treat and plating

debris, and mixed parts which don’t have the same head diameter as the

subject part, in the case of screws, or thickness, in the case of washers or nuts.

OPTICAL SORT – can sort shank length, presence of threads, head diameter, and

foreign material. A sort for these four parameters constitutes the basic “100 %

sort”, or “sort for automation”, and is sometimes incorrectly referred to as

“laser sort.” Missing washers, double washers, mixed sizes, head height, and in

some cases, hex size, can also be sorted.

FULL PROBES – can sort recess depth within .005”, and recess flaws due to broken

punches or plating fill using special accessory equipment (Phillips, Torx and Posi). Slotted & Hex drive presence and depth can be verified with a “Pin” sort.

VISION SORT – can sort shank length or major diameter* within .003”, threads on

both ends of a double ended stud, partial threads, thread run-ups (drunken threads)

sliders, and thread damage affecting a minimum of 180 degrees of the part diameter. Can also sort mixed point types, groove diameters, and internal lengths.

OVERHEAD VISION SORT – (Same as above) with added feature of sorting for

cracked heads (must be a burst/open crack, cannot detect diagonal cracks), excess flange, ballcaps, concentricity issues, flowering & out of round heads.

PACE EDDY CURRENT SORT – can sort for cracked heads on parts with a minimum size of M6 x 18mm with round heads (pan, truss binder, round etc.): a Phillips, Torx, or Posi drive configuration. Needed for hairline cracks on safety items.

LASER SORT – will sort parts of 5/8” minimum length for overall length, body

diameter, presence of threads & foreign material.

QUALIFIER SORT – can sort for multiple diameters, presence of threads / partial

threads, component lengths, overall length, & foreign material. Can sort the parts

for damage and other characteristics approximately 360 degrees around the part.

VISION NUT/WASHER SORT – can sort nuts for ID, thickness/height, burrs,

OD on round and flange nuts, width across corners and flats on square and hex

nuts, presence of threads, nylon ring, & foreign material. Can sort washers for

ID, OD, flatness, thickness, clipped, and foreign material.

EDDY CURRENT SORT/ MAGNETIC ANALYSIS – can sort mixed alloy,

cracks/voids and mixed hardness parts if there is a minimum uniform hardness difference of 8 points Rockwell C. (Known Good and Bad samples must be provided for evaluation and setup.)

*Accuracy of diameter sorts is affected by out-of-round condition. The more perfectly round the diameter, the more accurate the sort.

** PPM levels are based on characteristics being checked per sort & Dimension tolerances